Siemens Simovert Masterdrives Compact Plus Series - English

06.2006 Contents
Siemens AG 6SE7087-6KP50
SIMOVERT MASTERDRIVES Operating Instructions 0-1
Contents
1
DEFINITIONS AND WARNINGS..................................................................... 1-1
2 DESCRIPTION ................................................................................................. 2-1
3 TRANSPORT, STORAGE, UNPACKING........................................................ 3-1
4 FIRST START-UP ............................................................................................ 4-1
5 INSTALLATION ............................................................................................... 5-1
5.1 Installing the units............................................................................................. 5-1
5.2 Installing the optional boards............................................................................ 5-4
5.2.1 Installing optional boards on units with a width up to 90 mm ........................... 5-4
5.2.2 Installing optional boards on units with a width of 135 mm and 180 mm......... 5-7
6 INSTALLATION IN CONFORMANCE WITH EMC REGULATIONS .............. 6-1
7 CONNECTING-UP ........................................................................................... 7-1
7.1 Power connections ...........................................................................................7-5
7.1.1 Power connections for units with a width up to 90 mm .................................... 7-6
7.1.2 Power connections for units with a width of 135 mm and 180 mm .................. 7-7
7.2 Control connections.......................................................................................... 7-9
7.3 Conductor cross-sections ............................................................................... 7-19
7.4 Combinations of units ..................................................................................... 7-19
8 PARAMETERIZATION..................................................................................... 8-1
8.1 Parameter menus ............................................................................................. 8-1
8.2 Parameter input via the PMU............................................................................ 8-5
8.3 Parameter input via the OP1S.......................................................................... 8-8