Siemens simovert masterdrives User Manual

Faults and Alarms 10.99
6SE7087-6KP50 Siemens AG
12-30 Operating Instructions SIMOVERT MASTERDRIVES
Number / Alarm Cause Counter-measure
A212
Special function and
axis combination not
allowed
A different axis was programmed in the NC
block following a special function (M7 only).
Example:
N10 G50 X100 F1000
N15 G90 Y200 incorrect
N15 G90 X200 correct
The NC program number and NC block
number in which the NC block decoder
detected the error can be read out with the
"output actual values - decoder error location"
task.
Effect:
NC program execution is inhibited or aborted,
the axis is brought to a standstill via the
deceleration ramp.
Correct the NC program.The axis used in the
NC block with the special function must also
be programmed in the next NC block.
A213
Multiple D-number not
allowed
The decoded NC block contains several D
numbers.
Example:
N1 G41 D3 D5.
The NC program number and NC block
number in which the NC block decoder
detected the error can be read out with the
"output actual values - decoder error location"
task.
Effect:
NC program execution is inhibited or aborted,
the axis is brought to a standstill via the
deceleration ramp.
Correct the NC block.
A214
Multiple acceleration
behaviour not allowed
The decoded NC block contains several
mutually exclusive G functions from the
acceleration override group (G30 to G39).
Example:
N1 G34 G35
The NC program number and NC block
number in which the NC block decoder
detected the error can be read out with the
"output actual values - decoder error location"
task.
Effect:
NC program execution is inhibited or aborted,
the axis is brought to a standstill via the
deceleration ramp.
Correct the NC block.
A215
Multiple special
functions not allowed
The decoded NC block contains several
mutually exclusive G functions from the
special function group (G87, G88, G89, G50,
G51).
Example:
N1 G88 G50
The NC program number and NC block
number in which the NC block decoder
detected the error can be read out with the
"output actual values - decoder error location"
task.
Effect:
NC program execution is inhibited or aborted,
the axis is brought to a standstill via the
deceleration ramp.
Correct the NC block.

Siemens simovert masterdrives Specifications

General

Brand	Siemens
Model	simovert masterdrives
Category	DC Drives
Language	English