Siemens SIMOVERT OP1S - Table of Contents

OP1S Operator Control Panel
Siemens AG 477 459 4070 76 J AA-74
SIMOVERT MASTERDRIVES Operating Instructions
Contents
1 General...............................................................................................................1
2 Connecting, Run-up ..........................................................................................3
2.1 Connecting ..........................................................................................................3
2.2 Run-up.................................................................................................................5
3 Operator control ................................................................................................7
3.1 Operator control elements ...................................................................................7
3.2 Operating display.................................................................................................8
3.3 Basic menu..........................................................................................................9
3.4 Slave ID.............................................................................................................10
3.5 OP: Upread........................................................................................................11
3.6 OP: Download....................................................................................................12
3.7 Delete data........................................................................................................13
3.8 Menu selection ..................................................................................................14
3.8.1 Displaying and correcting parameters................................................................15
3.8.2 Fault and alarm messages ................................................................................20
3.9 Issuing commands via the OP1S.......................................................................21
4 Bus operation ..................................................................................................22
4.1 Configuring slaves .............................................................................................22
4.2 Change slave.....................................................................................................23
5 Technical data..................................................................................................24
Note
This operation manual of the OP1S is only valid for MASTER DRIVES
units with the control boards CUVC and CUMC and for MASTER
DRIVES Kompakt+ units.
The usage of the OP1S as spare part for the OP1 in conjunction with
the control boards CU1 (FC), CU2 (VC) and CU3 (SC) is described in
the operation manual of the OP1 with the order No. : 6SE7087-6CX84-
2FF0.