Commissioning
5.9 Parameters
Control Units CU240S
114 Operating Instructions, 07/2008 - FW 3.2, A5E00766042B AD
Quick commissioning
This parameter attribute identifies as to whether the parameter is included in the quick
commissioning (QC) (P0010 = 1).
Table 5-22 Parameter attributes - Quick commissioning
QC Description
No The parameter is not included in the quick commissioning
Yes The parameter is included in the quick commissioning
Value range
The value range, which is first specified by the data type, is restricted by minimum and
maximum values depending on the quantities of the inverter/motor. The values min and max
are permanently saved in the inverter and cannot be changed by the user. To support
commissioning each write parameter has a default value called factory setting.
Table 5-23 Parameter attributes - Value range
Value range Description
- No value entered (e.g.: "r parameter")
Min Minimum value
Max Maximum value
Def Default value
Data sets
A detailed description for the data sets is given in the respective section
Table 5-24 Data sets
BICO Description
CDS Command data set
DDS Drive data set
To Next Page
Loading...
