Siemens SINAMICS G120C - Guide through the manual

Installing
3.2 Connecting
SINAMICS G120C converter
26 Getting Started, 04/2014, FW V4.7, A5E34264105B AA
Default setting 7: Switch over between fieldbus and jogging using DI 3
Selected with
• STARTER: Fieldbus with data set switchover
• BOP-2: FB cdS
Factory setting for inverters with PROFIBUS interface
Default setting 8: Motorized potentio-
meter (MOP) with safety function
Selected with
• STARTER: MOP with Basic Safety
• BOP-2: MoP SAFE
PROFIdrive telegram 1
Fieldbus interface is not active.
Fieldbus interface is not active.
Default setting 9: Motorized
potentiometer (MOP)
Selected with
• STARTER: standard I/O with MOP
• BOP-2: Std MoP
Default setting 12: Two-wire control
with method 1
Selected with
• STARTER: Standard I/O with
analog setpoint
• BOP-2: Std ASP
Factory setting for inverters with USS
interface
Default setting 13: Setpoint via analog
input with safety function
Selected with
• STARTER: Standard I/O with
analog setpoint and safety
• BOP-2: ASPS
Fieldbus interface is not active.
Fieldbus interface is not active.
Fieldbus interface is not active.
Default setting 14: Switch over between fieldbus and motorized potentiometer
(MOP) using DI 3
Selected with
• STARTER: Process industry with fieldbus
• BOP-2: Proc Fb
PROFIdrive telegram 20
Fieldbus interface is not active.