9.7.4 Replacing the AOP30 operator panel
To replace the AOP30 operator panel, proceed as follows:
1. Switch off the main circuit-breaker.
2. Open the cabinet.
① Power supply
② Communication cable
③ Retaining lug
Figure 9-2 Replacement of the AOP30 operator panel
3. Disconnect the power supply ① communication cable ② at the operator panel.
4. Insert the retaining lugs ③ and pull the AOP30 operator panel to the front.
5. Snap in a new AOP30 operator panel.
6. Attach the connectors for the power supply and communications cable.
Maintenance
9.7 Repair
SINAMICS SM120 6SL38715
Operating Instructions 07/2015 95
To Next Page
Loading...
