S5-95U, SINEC L2 Programmer Functions Over the SINEC L2 Network
9.4 Editing a Path
Supposing you want to use a programmer connected direct to the SINEC L2 LAN to reach the
station with LAN address 2. The endpoint of the path is to be the S5-95U with the station address 2.
Figure 9-3 shows an example of how to edit the path ( Figure 9-3) with the "LAN SELECT" utility.
Figure 9-3. Path to be Edited with the "BUS DIALLING" Utility
S5-95U with SINEC L2 interface
PG
CP-L2
CP L2
ENDP
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
SINEC L2
Note
The "ENDP" control processor and "CP L2" communications processor are integrated
in the S5-95U programmable controller ( section 3.1, Figure 3-2).
You must therefore show the S5-95U as consisting of "CP L2" and "ENDP" as has
been done in Figure 9-3.
EWA 4NEB 812 6112-02
9-5
To Next Page
Loading...
