Siemens SINEC L2

Technical Specifications; Cycle Delay Times S5-95U, SINEC L2
PLC Cycle Delay Time
as Sender or Receiver
When PLC Scan
Cycle Loaded
Amount of
Data
PrerequisitesType of
Data Trans-
mission
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a
a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
a
a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a
Standard
connection
Sending and/or
receiving is
enabled
1 to
242 bytes
When sending:
The PLC scan
cycle is loaded
when the send job
is registered by the
operating system
(this takes place
within 10 ms)
When receiving:
The PLC scan
cycle is loaded
when receive data
has arrived at
receive mailbox.
Worst case for 1 byte:
550 µs
Worst case for
242 bytes:
650 µs
PLC-to-PLC
connection/
layer 2
services
When sending:
Send job is
possible
1 to 242
bytes
(PLC/PLC)/
0 to 242
bytes
(layer 2)
Every time an L2-
FB is invoked
(FB252, FB253)
When assigning
parameters direct to the
L2-FBs:
worst case for 1 byte:
500 µs
worst case for 242 bytes:
600 µs
When assigning
parameters indirectly to
the L2-FBs:
worst case for 1 byte:
550 µs
worst case for 242 bytes:
650 µs
When receiving:
Receive data
are available
Cyclic I/O
Cyclic I/O is
defined
ZP master: 1
to 128 words
ZPA and/or 1
to 128 words
ZPE
ZP slave:
1 to 121
words ZPA
and/or 1 to
121 words
ZPE
When transferring
the ZP data at the
ZP cycle
checkpoint (prior to
the OB1 cycle)
Worst case for 1 word
ZPA and 1 word ZPE:
400 µs
Worst case for 128 words
ZPA and 128 words ZPE:
600 µs
Programmer functions:
Programmer functions vary considerably regarding their influence on the cycle delay time and
therefore no generally valid times can be specified.
E-4 EWA 4NEB 812 6112-02