Siemens SINUMERIK 804D sl Operation/Programming

3
08/2005 Machining the Workpiece
3
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition 3-89
Machining the Workpiece
3.1 Starting/stopping machining...................................................................................... 3-90
3.2 Running-in a program...............................................................................................3-93
3.3 Displaying the current program block .......................................................................3-94
3.4 Repositioning the axes.............................................................................................. 3-95
3.5 Starting the machining at a specific point in the program......................................... 3-96
3.6 Controlling the program .......................................................................................... 3-102
3.7 Overstoring.............................................................................................................. 3-103
3.8 Testing a program...................................................................................................3-105
3.9 Correcting the program........................................................................................... 3-106
3.10 Displaying G and auxiliary functions.......................................................................3-107
3.11 Simulating machining.............................................................................................. 3-108
3.11.1 Simulation before the machining of the workpiece ................................................. 3-110
3.11.2 Parallel drawing before the machining of the workpiece ........................................ 3-112
3.11.3 Parallel drawing while the workpiece is being machined........................................ 3-113
3.11.4 Modifying the shape of a blank for a G-code program ...........................................3-113
3.11.5 Various views of the workpiece............................................................................... 3-114
3.11.6 Changing the cut-away ........................................................................................... 3-118
3.12 Automatic mode settings......................................................................................... 3-120
3.12.1 Establishing the test-run feedrate...........................................................................3-120
3.12.2 Parameterizing the workpiece counter ................................................................... 3-121

Siemens SINUMERIK 804D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 804D sl
Category	Control Systems
Language	English