Siemens SINUMERIK 808D ADVANCED

Programming and Operating — Turning Page 26 808D ADVANCED
Create Part
Program
Part 1
s
Create
program
The following sequence should be followed to create
a part program:
Step 1
Programs can be
created with the
“program manager”.
You can select the
“program manager”
using the key
located on the PPU.
Step 2
Select NC as the storage location for the
program. Programs can only be created
in the NC.
Step 3
Create a new
program with
the “New” SK
on the right of
the PPU.
Step 4
1
2
Step 5
End
Now the
program is
open and
can be
edited.
After editing the system will save it automatically.
You can
choose
“New” or
“New direc-
tory”.
Choose
“New” to
create a
program.
Choose
“New direc-
tory” to
create a
folder.
BASIC THEORY