808D ADVANCED Page 7 Programming and Operating — Turning
Preparation
s
Machine
coordinate
system
The Sinumerik 808D
ADVANCED uses a
coordinate system which is
derived from the DIN
66217 standard.
The system is an interna-
tional standard and en-
sures compatibility be-
tween machines and coor-
dinate programming.
The primary function of the
coordinate system is to
ensure that the tool length
and tool radius are calcu-
lated correctly in the re-
spective axis.
Passwords
Changing
password
Step 1
The service mode is opened
with the appropriate key
combination.
In the service mode, the
password can be activated
and deactivated.
Step 2
Enter customer password
Change customer password
Delete customer password
The machine zero point (M) is determined by the machine manufacturer
and cannot be changed.
The workpiece zero point (W) is the origin of the workpiece coordinate
system.
The reference point (R) is used for synchronizing the measuring
system. synchronizing is used for synchronizing the measuring system
The tool holder reference point (F) is used to determine the tool offset.
Usually the machine operator does not need to
change the password.
End
+
Passwords at the control are used to set the user’s
right to access the system. Tasks such as ”Basic Op-
erating”, “Advanced Operating” and commissioning
functions all depend on the passwords.
No password Machine operator
Customer’s password Advanced operator
Manufacturer’s password OEM engineer
Customer’s password = CUSTOMER
Manufacturer’s password = SUNRISE
SEQUENCE
To Next Page
Loading...
Need help?
General
