Milling Part 1: Operation
Programming and Operating Manual, 12/2012, 6FC5398-4DP10-0BA0
3
Preface
Purpose of the manual
This manual provides information about programming and operating the SINUMERIK 808D
CNC on milling machines.
My Documentation Manager (MDM)
Under the following link you will find information to individually compile your documentation
based on the Siemens content:
www.siemens.com/mdm
Target group
This manual is intended for the following audience:
● End users of milling machines installed with SINUMERIK 808D control systems, including
operators, programmers and maintenance engineers
● Service engineers of the machine tool manufacturer
Standard scope
This manual only describes the functionality of the standard version. Extensions or changes
made by the machine tool manufacturer are documented by the machine tool manufacturer.
Technical support
Hotline: +86 400-810-4288
Service and Support
China:
www.siemens.com.cn/808D
Worldwide:
http://support.automation.siemens.com
EC Declaration of Conformity
The EC Declaration of Conformity for the EMC Directive can be found on the Internet at
http://support.automation.siemens.com
Here, enter the number 15257461 as the search term or contact your local Siemens office.
To Next Page