Siemens Sinumerik 840 sl Operation & Programming Manual

5
08.02 Turning with Cycles
5.3 Stock removal/
g
roovin
g
c
y
cles in STOCK REMOVAL mode
5
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition 5-101
The part is finished in the same direction as it is rough-cut. The cycle
automatically selects and deselects tool radius compensation as
required during finishing.
Sequence of operations
Precondition
Select STOCK REMOVAL mode and call the required stock removal
cycle by pressing the soft key.
Simple stock removal cycle conical
Simple stock removal cycle
straight

Siemens Sinumerik 840 sl Specifications

General

Brand	Siemens
Model	Sinumerik 840 sl
Category	Control Unit
Language	English