Siemens Sinumerik 840 sl Operation & Programming Manual

6
08.02 Turning any Contours (Free Contour Input)
6
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition 6-111
Turning any Contours (Free Contour Input)
6.1 General notes.......................................................................................................... 6-112
6.2 Create new contour................................................................................................. 6-113
6.3 Symbolic representation of contour......................................................................... 6-114
6.4 Graphic representation of contour........................................................................... 6-115
6.5 Create contour elements......................................................................................... 6-116
6.6 Editing contour elements......................................................................................... 6-119
6.7 Stock removal against contour................................................................................ 6-122
6.8 Machining residual material .................................................................................... 6-126
6.9 Single-cycle machining............................................................................................ 6-127

Siemens Sinumerik 840 sl Specifications

General

Brand	Siemens
Model	Sinumerik 840 sl
Category	Control Unit
Language	English