Siemens Sinumerik 840 sl Operation & Programming Manual

6
08.02 Turning any Contours (Free Contour Input)
6.6 Editin
g
contour elements
6
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition 6-121
Creating a new contour
Contour
new
Press soft key "Contour new".
Once you have confirmed the prompt again (soft key "OK" or "Return")
by pressing the "OK" soft key, you can start a new contour.
The contour you have already defined is stored under the name you
have given it.

Siemens Sinumerik 840 sl Specifications

General

Brand	Siemens
Model	Sinumerik 840 sl
Category	Control Unit
Language	English