Siemens Sinumerik 840 sl Operation & Programming Manual

0
Contents 08.02
0
© Siemens AG, 2002. All rights reserved
0-6 SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
Turning Simple Contours 4-63
4.1 Turning in manual mode............................................................................................ 4-64
4.2 Turning with path dimension input.............................................................................4-66
4.2.1 Turning with STRAIGHT mode..................................................................................4-67
4.2.2 Turning with CONICAL mode.................................................................................... 4-69
4.2.3 Turning with CIRCLE mode.......................................................................................4-71
4.3 Turning with the contour handwheel and JOG keys +/–............................................ 4-75
Turning with Cycles 5-79
5.1 General notes ............................................................................................................ 5-80
5.2 Turning cycles in CYCLE mode................................................................................. 5-81
5.2.1 Thread cutting ...........................................................................................................5-81
5.2.2 Controlling thread cutting operations.........................................................................5-87
5.2.3 Re-working a thread .................................................................................................. 5-88
5.2.4 Undercuts Form E and F ...........................................................................................5-89
5.2.5 Thread undercuts ......................................................................................................5-91
5.2.6 Drilling in longitudinal axis (center)............................................................................5-93
5.2.7 Hole circle drilling ......................................................................................................5-97
5.3 Stock removal/grooving cycles in STOCK REMOVAL mode.................................. 5-100
5.3.1 Stock removal cycles...............................................................................................5-100
5.3.2 Grooving cycles ....................................................................................................... 5-105
Turning any Contours (Free Contour Input) 6-111
6.1 General notes .......................................................................................................... 6-112
6.2 Create new contour .................................................................................................6-113
6.3 Symbolic representation of contour ......................................................................... 6-114
6.4 Graphic representation of contour........................................................................... 6-115
6.5 Create contour elements .........................................................................................6-116
6.6 Editing contour elements .........................................................................................6-119
6.7 Stock removal against contour ................................................................................6-122
6.8 Machining residual material..................................................................................... 6-126
6.9 Single-cycle machining............................................................................................ 6-127
Program Creation with EasyStep and G Code 7-129
7.1 General notes .......................................................................................................... 7-130
7.2 Creating a machining sequence..............................................................................7-131
7.3 Display machining sequence................................................................................... 7-132
7.4 Program steps ......................................................................................................... 7-133
7.4.1 Inserting new program step.....................................................................................7-133
7.4.2 Special functions ..................................................................................................... 7-134

Siemens Sinumerik 840 sl Specifications

General

Brand	Siemens
Model	Sinumerik 840 sl
Category	Control Unit
Language	English