Siemens SINUMERIK 840D sl Ctrl-Energy User Manual

An energy-saving profile runs through the displayed automatic state machine if the associated
"energy-saving profile initialized" bit is set. The HMI resets this bit before changing the times
or the signal mask, and sets it after the values have been consistently written into the PLC.
When the "Energy-saving profile active" bit is set, then an energy-saving profile is considered
to have been assigned.
7UDQVLWLRQ
581
7UDQVLWLRQ
581
7UDQVLWLRQ
581
7

KDVH[SLUHG
'LUHFWO\DFWLYDWH
HQHUJ\VDYLQJSURILOH
VHW
'LUHFWO\DFWLYDWH
HQHUJ\VDYLQJSURILOH
VHW
7UDQVLWLRQ
2))
'LUHFWO\DFWLYDWH
HQHUJ\VDYLQJSURILOH
VHW
6HWWLPHWR
SUHZDUQLQJOLPLW
ORDG7

ZLWK
VHWSRLQW
7UDQVLWLRQ
2))
7UDQVLWLRQ
2))
7

KDVH[SLUHG
(QHUJ\
VDYLQJVWDWH
LQDFWLYH
(QHUJ\
VDYLQJVWDWH
DFWLYH
7LPHU7

LV
GHFUHPHQWHG
7LPHU7

LV
GHFUHPHQWHG
Figure 4-1 State monitoring
Transition to "RUN"
All of the signals that have been enabled for evaluation using the following masking bits, are
inactive
(also see Chapter 3.1.5.2.):
DBX 11.0, DBX 11.1, DBX 11.2 HMI activities
DBX 12.0 MCP activities
DBX 13.0 – DBX 13.7 NCK channel activities
DBX 14.0, DBX 14.1 NCK channel activities
DBX 15.0, DBX 15.1 Master computer and PLC prohibit signals
The specified signals refer to energy-saving profile 1.
Ctrl-E Profiles
4.1 Commissioning the PLC for Ctrl-E Profiles
Ctrl-Energy
System Manual, 01/2015, 6FC5397-0EP40-5BA2 41

Siemens SINUMERIK 840D sl Ctrl-Energy Specifications

General

Brand	Siemens
Model	SINUMERIK 840D sl Ctrl-Energy
Category	Controller
Language	English