Siemens SINUMERIK 840DE SL - Page 142

4
Creating a ShopTurn Program 08/2005
4
♥ Siemens AG, 2005. All rights reserved
4-142 SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
Teach TC
position
 Press the "Teach TC position" softkey if you want to set the
current position of the tool as a tool change point.
The tool’s coordinates are adopted by the parameters XT and ZT.
 Press the "Accept" softkey.
The work plan is displayed.
ShopTurn has automatically defined the end of the program.