Siemens SINUMERIK 840DE SL - Program Management

9
08/2005 Program Management
9
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition 9-373
Program Management
9.1 Managing programs with ShopTurn........................................................................ 9-374
9.2 Managing programs with ShopTurn on NCU (HMI Embedded) .............................9-375
9.2.1 Opening a program .................................................................................................9-377
9.2.2 Executing a program...............................................................................................9-378
9.2.3 Executing a G-code program from the USB-network-drive ....................................9-379
9.2.4 Creating a Nnew directory/program........................................................................9-380
9.2.5 Marking several programs.......................................................................................9-381
9.2.6 Copying/renaming a directory/program...................................................................9-382
9.2.7 Deleting a directory/program...................................................................................9-383
9.2.8 Saving/reading-in tool/zero-point data ....................................................................9-384
9.3 Managing programs with PCU 50.3 (HMI Advanced).............................................9-387
9.3.1 Opening a program .................................................................................................9-389
9.3.2 Executing a program...............................................................................................9-390
9.3.3 Loading/unloading a program .................................................................................9-391
9.3.4 Executing a G-code program from the hard-disk or diskette/USB/network drives .9-392
9.3.5 Creating a new directory/program...........................................................................9-394
9.3.6 Marking several programs.......................................................................................9-395
9.3.7 Copying/renaming/moving a directory or program..................................................9-396
9.3.8 Delete directory/program.........................................................................................9-398
9.3.9 Saving/reading-in the tool/zero-point data..............................................................9-398