Siemens SINUMERIK 840DE SL

To Next Page

To Previous Page

ShopTurn Functions 08/2005

5-154 SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition

5.5.1 Rectangular pocket .................................................................................................5-236

5.5.2 Circular pocket.........................................................................................................5-240

5.5.3 Rectangular spigot ..................................................................................................5-243

5.5.4 Circular spigot..........................................................................................................5-247

5.5.5 Longitudinal slot.......................................................................................................5-250

5.5.6 Circumferential slot..................................................................................................5-253

5.5.7 Positions..................................................................................................................5-257

5.5.8 Multiple edge ...........................................................................................................5-258

5.5.9 Engraving ................................................................................................................5-260

5.6 Contour milling ........................................................................................................5-267

5.6.1 Representation of the contour.................................................................................5-270

5.6.2 Creating a new contour ...........................................................................................5-272

5.6.3 Creating contour elements ......................................................................................5-274

5.6.4 Changing a contour.................................................................................................5-281

5.6.5 Path milling..............................................................................................................5-283

5.6.6 Predrilling a contour pocket.....................................................................................5-288

5.6.7 Milling a contour pocket (roughing).........................................................................5-292

5.6.8 Removing residual material from a contour pocket.................................................5-295

5.6.9 Finishing the contour pocket ...................................................................................5-297

5.6.10 Chamfering a contour pocket ..................................................................................5-301

5.6.11 Milling a contour spigot (roughing) ..........................................................................5-302

5.6.12 Removing residual material from a contour spigot..................................................5-305

5.6.13 Finishing the contour spigot ....................................................................................5-307

5.6.14 Chamfering a contour spigot ...................................................................................5-310

5.7 Calling a subroutine.................................................................................................5-312

5.8 Repeating program blocks ......................................................................................5-314

5.9 Machining with the counterspindle..........................................................................5-315

5.10 Changing program settings.....................................................................................5-321

5.11 Calling work offsets.................................................................................................5-322

5.12 Defining coordinate transformations .......................................................................5-323

5.13 Programming the approach/return cycle.................................................................5-326

5.14 Inserting G code into the sequential control program .............................................5-327

5.15 Teaching..................................................................................................................5-329

5.15.1 Teaching a cycle......................................................................................................5-329

5.15.2 Teaching a position sample.....................................................................................5-330

5.15.3 Teaching a contour object.......................................................................................5-331

Siemens SINUMERIK 840DE SL - Page 154