Siemens SINUMERIK 840DE SL - Page 234

5
ShopTurn Functions 08/2005
5.4 Contour turnin
g
5
♥ Siemens AG, 2005. All rights reserved
5-234 SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
U1 Compensation allowance in X and Z direction (inc) – (with allowance only)
Positive value: Compensation allowance is not removed
Negative value: Compensation allowance is removed in addition to finishing
allowance
mm
DI Distance after which feed interruption occurs - (only for roughing) mm
Set machining
area limits
Limit machining area or not
XA Limit X (abs) – (with limited machining area only) mm
XB Limit X (abs or inc) – (with limited machining area only) mm
ZA Limit Z (abs) – (with limited machining area only) mm
ZB Limit Z (abs or inc) – (with limited machining area only) mm
N Number of grooves