Siemens SINUMERIK 840DE SL - Page 24

1
Introduction 08/2005
1.2 Workstation
1
♥ Siemens AG, 2005. All rights reserved
1-24 SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
Ctrl
Use the following key combinations to navigate in the process plan
and in the G code editor:
 Ctrl + Home: Jump to the beginning.
 Ctrl + End: Jump to the end.
Alt
Has no meaning for ShopTurn.
Del
 Deletes the value in the parameter field.
 In insertion mode, it deletes the character marked by the cursor.
 Deletes the machining lines during parallel drawing and in the
simulation.
Insert
Activates insertion mode or the pocket calculator.
Input
 Terminates entry of a value in the input field.
 Opens a directory or program.
Alarm - only OP 010 and OP 010C
Opens the "Messages/Alarms" operating area.
This key has the same function as the "Alarm list" softkey.
Program - only OP 010 and OP 010C
Opens the "Program" operating area.
This key has the same function as the "Prog. edit" softkey.
Offset - only OP 010 and OP 010C
Opens the "Tools/Offsets" operating area.
This key has the same function as the "Tool zero point" softkey
Program Manager - only OP 010 and OP 010C
Opens the "Program Manager" operating area.
This key has the same function as the "Program" softkey.