Siemens SINUMERIK 840DE SL - Page 308

5
ShopTurn Functions 08/2005
5.6 Contour millin
g
5
♥ Siemens AG, 2005. All rights reserved
5-308 SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
Parameters Description of finishing the base Unit
T, D, F, S, V See Sec. "Creating program blocks".
Position Select from 8 different positions:
 End face/End face C – Front
 End face/End face C – Rear
 Peripheral surface/Peripheral surface C – Inner
 Peripheral surface/Peripheral surface C – Outer
 End face Y – Front (only when Y axis exists)
 End face Y – Rear (only when Y axis exists)
 Peripheral surface Y – inner (only when Y axis exists)
 Peripheral surface Y – Rear (only when Y axis exists)
Clamp/release spindle (for End face Y/Peripheral surface Y only)
The function must be set up by the machine manufacturer.
Machining
type
Finishing the base
Z0
Z1
DXY
UXY
UZ
End face/End face C:
Reference point in Z direction (abs.)
Depth with reference to Z0 (abs. or inc.)
Maximum infeed in the XY plane
Plane infeed in %: Ratio of plane infeed (mm) to milling cutter diameter (mm)
Finishing allowance in plane
Finishing allowance in depth
mm
mm
mm
%
mm
mm
X0
X1
DYZ
UYZ
UX
Peripheral surface/Peripheral surface C:
Cylinder diameter ¬ (abs.)
Depth with reference to X0 ¬ (abs. or inc.)
Maximum infeed in the YZ plane
Plane infeed in %: Ratio of plane infeed (mm) to milling cutter diameter (mm)
Finishing allowance in plane
Finishing allowance in depth
mm
mm
mm
%
mm
mm
CP
Z0
Z1
DXY
UXY
UZ
End face Y:
Reference point
Reference point in Z direction (abs.)
Depth with reference to Z0 (abs. or inc.)
Maximum infeed in the XY plane
Plane infeed in %: Ratio of plane infeed (mm) to milling cutter diameter (mm)
Finishing allowance in plane
Finishing allowance in depth
Degrees
mm
mm
mm
%
mm
mm