5
ShopTurn Functions 08/2005
5.12 Definin
coordinate transformations
5
♥ Siemens AG, 2005. All rights reserved
5-324 SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
C axis rotation
You can turn the C axis through a specific angle to enable
subsequent machining operations to be performed at a particular
position on the end face or peripheral surface.
The direction of rotation is set in a machine data code.
Please also refer to the machine manufacturer's instructions.
New C axis rotation
Additive C axis rotation
Scaling
You can specify a scale factor for the active machining plane as
well as for the tool axis. The programmed coordinates are then
multiplied by this factor.
New scaling
Additive scaling
To Next Page
Loading...
