Sequence for a TCU
Procedure:
1. Connect TCU.
This opens the dialog "New operator panel (TCU)".
2. Select "New" to connect a new TCU and "OK" to conrm.
3. In the next dialog, accept the name suggested by the system or enter a name and conrm this
with "OK".
The following parameters are pre-selected for the TCU:
Operator panel index - TCU [0-255]
Machine control panel address - MCP [0-255]
Electronic key system index - EKS [0-255]
Enable direct keys
1_
192
0
No
4. Restart the TCU to apply the new settings.
5. If you want to change the parameters, select "Main menu" → "Service this panel" → "Modify
operator panel settings".
General information and networking
4.3Networking
Handheld Terminal HT 8
56 Equipment Manual, 02/2024, A5E52918633B AA
To Next Page
Loading...
