Siemens SINUMERIK 840Di - Page 1086

Detailed description
2.12 Block descriptions
Power Line Basic PLC Program (P3)
2-174 Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
Call example
As far as timing is concerned, the basic program can be executed after other user programs.
This is advisable since the FC5 circuitry will place the PLC in Stop mode.
This example contains the standard declarations for OB82 and OB86 and the call of the
basic program block.
ORGANIZATION_BLOCK OB 82
VAR_TEMP
OB82_EV_CLASS : BYTE ;
OB82_FLT_ID : BYTE ;
OB82_PRIORITY : BYTE ;
OB82_OB_NUMBR : BYTE ;
OB82_RESERVED_1 : BYTE ;
OB82_IO_FLAG : BYTE ;
OB82_MDL_ADDR : INT ;
OB82_MDL_DEFECT : BOOL ;
OB82_INT_FAULT : BOOL ;
OB82_EXT_FAULT : BOOL ;
OB82_PNT_INFO : BOOL ;
OB82_EXT_VOLTAGE : BOOL ;
OB82_FLD_CONNCTR : BOOL ;
OB82_NO_CONFIG : BOOL ;
OB82_CONFIG_ERR : BOOL ;
OB82_MDL_TYPE : BYTE ;
OB82_SUB_NDL_ERR : BOOL ;
OB82_COMM_FAULT : BOOL ;
OB82_MDL_STOP : BOOL ;
OB82_WTCH_DOG_FLT : BOOL ;
OB82_INT_PS_FLT : BOOL ;
OB82_PRIM_BATT_FLT : BOOL ;
OB82_BCKUP_BATT_FLT : BOOL ;
OB82_RESERVED_2 : BOOL ;
OB82_RACK_FLT : BOOL ;
OB82_PROC_FLT : BOOL ;
OB82_EPROM_FLT : BOOL ;
OB82_RAM_FLT : BOOL ;
OB82_ADU_FLT : BOOL ;
OB82_FUSE_FLT : BOOL ;
OB82_HW_INTR_FLT : BOOL ;
OB82_RESERVED_3 : BOOL ;
OB82_DATE_TIME : DATE_AND_TIME;
END_VAR