Detailed Description
2.1 Axes
Axis Types, Coordinate Systems, Frames (K2)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
2-13
Application
In the case of helical interpolation FGROUP can be programmed to determine whether:
• The programmed feedrate should be valid on the path
(all 3 programmed axes are path axes)
• The programmed feedrate should be valid on the circuit
(2 axes are path axes and the infeed axis is a synchronous axis)
2.1.11 Axis configuration
The figure below shows the assignment between the geometry axes, special axes, channel
axes and machine axes as well as the names of the individual axis types. MD are used for
assignment.
To Next Page
Loading...
