Auxiliary Function Output to PLC (H2)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
Index-1
Index
$
$P_SEARCH_S, 2-31
$P_SEARCH_SDIR, 2-31
$P_SEARCH_SGEAR, 2-31
$P_SEARCH_SPOS, 2-31
$P_SEARCH_SPOSMODE, 2-31
A
Address extension, 2-23
Area
Output duration, 2-22
Output relative to motion, 2-22
Areas of the output behavior, 2-21
Auxiliary function output
Block search, 2-29
Auxiliary function without auxiliary function group, 2-29
Auxiliary functions of auxiliary function group 1, 2-29
B
Behavior regarding
M19, 2-30
C
Collected direction of rotation, 2-33
Collected S values, 2-33
Constraints
Auxiliary function: M1, 3-3
Auxiliary functions: M17 or M2 / M30, 3-2
DL (additive tool offset), 3-1
Maximum number of auxiliary functions per part
program block, 3-1
Part program blocks without traverse
movement, 3-3
Spindle replacement, 3-1
Synchronized actions, 3-2
Tool management, 3-1
Constraints, 2-25, 2-33
Thread cutting, 3-2
Continuous-path mode, 2-25
D
D functions, 1-6
Definition of an auxiliary function, 1-2
DL functions, 1-7
E
Extension of predefined auxiliary functions, 2-12
F
F functions, 1-7
FA functions, 1-8
Fast acknowledgment, 2-6, 2-25
G
Group assignment, 2-14
Grouping together auxiliary functions, 2-4
M
M functions, 1-3
M98, 2-28
Maximum number, 2-12
MD10713, 2-27
MD10715, 2-28
MD11100, 2-12
MD11110, 2-22
MD11450, 2-30
MD20090, 3-1
MD20124, 3-1
MD20800, 3-2, 3-3
MD22000, 2-14, 2-16, 2-17, 2-18
MD22010, 2-14, 2-16, 2-17, 2-18
To Next Page
Loading...
Need help?
General
