Siemens SINUMERIK 840Di - 2.4 Closed-loop control; 2.4.1 General

Detailed Description
2.4 Closed-loop control
Velocities, Setpoint/Actual-Value Systems, Closed-Loop Control (G2)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
2-49
Intermediate gear encoder on tool
Q
(1&B,6B',5(&7 
(1&B,6B',5(&7 
Q
(1&B5(62/
'5,9(B(1&B5$7,2B180(5$
'5,9(B(1&B5$7,2B'(120
'5,9(B$;B5$7,2B180(5$
'5,9(B$;B5$7,2B'(120
Q
(1&B,6B',5(&7 
(1&B,6B',5(&7 
(1&B,6B',5(&7 
(1&B,6B',5(&7 
'5,9(B$;B5$7,2B180(5$
'5,9(B$;B5$7,2B'(120
0
*
1XPEHURIPRWRUUHYROXWLRQV
1XPEHURIHQFRGHUUHYROXWLRQV
1RRIPRWRUUHYV
1RRIVSLQGOHUHYV
(QFRGHU
0HDV
JHDU
0RWRU
/RDG
JHDU
,QWHUPHGLDWHJHDU
7RRO
1RRIORDGUHYV
1RRIVSLQGOHUHYV
5RWDWLQJWRRO
7RRO
Fig. 2-11 Intermediate gear with encoder directly on the rotating tool
In order to adapt the actual-value resolution to the calculation resolution, the control
calculates the quotients from the "internal increments/mm" and the "encoder increments/mm"
as follows:
'5,9(B(1&B5$7,2B180(5$>Q@
,17B,1&5B3(5B'(*

'5,9(B(1&B5$7,2B'(120>Q@

GHJUHHV
,QWHUQDOLQFUHPHQWVGHJUHHV
(QFRGHULQFUHPHQWVGHJUHHV
(1&B5(62/>Q@LQWHUQDOPXOWLSOLFDWLRQ
2.4 2.4 Closed-loop control
2.4.1 General
Position control of an axis/spindle
The closed-loop control of an axis consists of the current and speed control loop of the drive
plus a higher-level position control loop in the NC.