Siemens SINUMERIK 840Di System Overview

SINUMERIK® documentation
This document is included in the documentation on CD-ROM (DOCONCD).
Edition Order No. Remark
08.01 6FC5298-6CA00-0BG1 C
Trademarks
SIMATIC , SIMATIC HMI , SIMATIC NET , SIROTEC , SINUMERIK and SIMODRIVE are registered
trademarks of Siemens. Third parties using for their own purposes any other names in this document which refer
to trademarks might infringe upon the rights of trademark owners.
Printing histor
y
Brief details of this edition and previous editions are listed below.
The status of each edition is shown by the code in the "Remarks" column.
Status codes in the "Remarks" column:
A .... New documentation.
B .... Unrevised reprint with new order number.
C .... Revised edition with new status.
If factual changes have been made on the page since the last edition, this is indicated by a new edition
coding in the header on that page.
Edition Order No. Remarks
01.00 6FC5298-5AE40-0BP0
A
02.01 6FC5298-6AE40-0BP0
C
Further information is to be found on the Internet at:
http://www.ad.siemens.de/sinumerik
This publication was produced with WinWord V 8.0 and Designer V 6.0,
as well as with the DocTool AutWinDoc.
The reproduction, transmission or use of this document or its contents
is not permitted without express written authority. Offenders will be
made liable for damages. All rights, including rights created by patent
grant or registration of a utility model or design, are reserved.
© Siemens AG 2001. All Rights Reserved.
Other functions not described in this documentation might be
executable in the control. This does not, however, represent an
obligation to supply such functions with a new control or when
servicing.
We have checked that the contents of this document correspond to the
hardware and software described. Nonetheless, differences might
exist and therefore we cannot guarantee that they are completely
identical. The information contained in this document is, however,
reviewed regularly and necessary changes will be included in the next
edition. We welcome suggestions for improvement.
Subject to change without prior notice.
Order No. 6FC5298-6AE40-0BP0
Printed in the Federal Republic of Germany
Siemens-Aktiengesellschaft.

Siemens SINUMERIK 840Di Specifications

General

Brand	Siemens
Model	SINUMERIK 840Di
Category	Control Unit
Language	English