Installation
9229 0025 176 0A 39
2019-08-05
Mounting the retaining angle for the cable outlet
The version with plug or terminal strip (without low-voltage plug) is supplied with a
retaining angle (60) and fixing materials in the supplementary equipment. The re-
taining angle serves to bundle and protect the cables coming from the low-voltage
interface.
Self-tapping screws are suitable for single use only.
Mount the retaining angle (60) with the cable harness so
that the cable harness is routed to the back of the pole
shells.
Fit the retaining angle with the self-tapping screws (Torx
screwdriver, size 20) and a tightening torque of
3±0.3Nm.
For the wiring of the connector strip or terminal strip refer
to page 46.
Fig. 52 Example - Mounting the retaining angle for the
cable outlet
To Next Page
Loading...
