Index
9229 0025 176 0A 65
2019-08-05
Index
A
Accessories available for order
 .............................  62
Altitude correction factor
  .......................................  32
Ambient conditions
 ................................................  32
Anti-pumping device
  .............................................  18
Anti-pumping device (-K1)
  ............................  17,   20
Areas of application
  ..............................................  11
Auxiliary contactor (-K1)
 ........................  16–  17,  20
Auxiliary switch (-S1)
  ............................  16–  18,   22
B
Basic equipment
  ...................................................   18
Bushing
 .................................................................   53
C
C.t.-operated release
(-Y4)
 ........................................................   18,   25
(-Y5)
 ........................................................   18,   25
(-Y6)
 ........................................................   18,   25
Cable harness
 .......................................................   47
Cable outlet
 ...........................................................   18
Circuit-breaker tripping signal (-S6)
  ......  16–  18,   23
CLOSE pushbutton
 ...............................................   15
Closing lock-out (-Y8E), electrical
 .........  17–  18,   30
Closing solenoid (-Y9)
 ...........................  16–  18,  20
Closing spring
  ...............................  16–  17,   59–  60
Conductor bar
  .......................................................   50
Connection bar
 ......................................................   50
Connection thread
 .................................................  50
Connector strip
(Q0-X1.1, Q0-X1.2, Q0-X1.3)
 .........................  18
20-pole
 ............................................................   46
Contact arm
  ..................................................   51–  52
Contact arm adapter
  .............................................   52
Contact surface, pole
 ............................................   50
Contact system
  .....................................  14,   52– 53
Cover
  ....................................................  13–  15,   37
mounting
 .........................................................   37
removing
 .........................................................   37
D
Dielectric strength
  .................................................   32
Disconnected position
 ...........................................   28
Dowel pin
  ..............................................................   51
E
Earthing terminal
 ...................................................  45
F
Factory number
 .....................................................   31
H
Hand crank
 ....................................................  15,   59
Hand crank coupling
  .....................................   15–  17
Handle, withdrawable part
  ....................................   55
Heater (-R01)
 ........................................  16–  18,   27
High-voltage protective earth
 ................................   45
I
Installation altitudes
 ...............................................  32
Installation position
 ................................................  36
Interlock, mechanical
 ....................................   18,   28
Interlocks
  ...............................................................  28
IP plate
  .........................................................   18,   43
Isolator
 ..........................................................   13–  15
K
Key-operated interlock
 ..........................   15–  18,   30
L
Low-voltage
interface (-X0)
  ........................................   18,   46
plug connector (-X0)
 ...............   13–  14,   16–  17
plug-connector with sleeve housing
 ................  18
M
Manual closing, mechanical
  ..................................  18
Manual opening, mechanical
 .................................  18
Mating contact
  .......................................................  53
Motor (-M1)
 ...........................................   16,   18–  19
Motor gear unit (-M1)
 .............................................  17
Motor short-circuit protection
 .................................  19
Movement
 ..............................................................  55
N
Name plate
  ...........................................   13–  14,   31
O
OPEN pushbutton
 ..................................................  15
Opening spring
  ......................................................  60
Operating mechanism
  ...........................................  15
Operating position
  .................................................  28
Operations counter
 .......................................   15–  18
P
Plug
(-Q0)
 ................................................................  47
(Q0-X1)
  ..................................................   16–  17
(-Q1)
 ................................................................  47
(-X01) and (-X02)
  ...................................   16–  17
withdrawable part
 ............................................  47
Pole assembly
  .......................................................  14
Pole contact plate
 .........................................   13–  14
Pole head
  .....................................................   13–  14
Pole shell
 ..............................................   13–  14,   40
Pole-centre distance
 ..............................................  31
Position indicator CLOSED-OPEN
 ...............   15–  17
Position switch
 .......................................................  21
(-S12)
  .....................................................   16–  18
(-S21)
  .............................................   16–  18,   21
(-S3)
  ...............................................   16–  18,   21
(-S4)
  ...............................................   16–  18,   21
(-S5)
  .......................................................   17– 18
(-S6)
  ...............................................   16–  17,   23