Installation
9229 0025 176 0A 53
2019-08-05
adapter) on one side of the inside (round outer edge) on the contact fingers with
Molykote Longterm 2.
• Fit contact system onto threaded rod and contact arm, observing position of the
contact system (round outer edge towards contact arm).
• Tighten contact system with torque spanner.
Tightening torque for
- M12: 40 ±4 Nm
- M16: 100 ±10 Nm
Tightening torques apply to greased threads only.
• Grease the other side of the contact system with Molykote Longterm 2.
Mounting the bushing and mating contact
The plate must be provided by the customer (for the dimensions, see the supplied
dimension drawing).
Screw bushings with mating contact, each with
• 4 DIN 603 M8x25-8.8 carriage bolts with square
neck
• contact washers and
• hexagon nuts
to the plate (made of non-ferromagnetic steel) in the pan-
el or the rear of the guide frame.
Tightening torque for
- M8: 25 ±2 Nm
Tightening torques apply to greased threads only.
Fit bushing cap from the other side.
Fig. 88 Mounting a bushing with mating contact to the
guide frame or the plate
To Next Page
Loading...
