3 Operation
3.3 Configuring Mode (Parameterization and Configuring Mode)
3.3.2 Parameterization Mode AdAP (Adaptation)
Manual
140
SIP ART DR24 6DR2410
C79000-G7476-C153-03
parameters. After returning to the parameterization mode AdAP the
**
.n parameters are identi-
fied by Strt AdAP.
The transfered parameters do not affect the process until the process operation mode has
switched to Automatic after pressing the Exit key (tA1).
When controlling the parameters with the appropriate control inputs of the controllers, it is not
recommendable to transfer the new parameters directly because the function generators follow-
ing the controlling variable need to be set accordingly. In this case the new parameters must be
noted in pairs to the controlling variable to set the function transmitter accordingly. The control-
ling variable must be displayed during adaptation. To do this use the controller output AL
(adaptation in progress) and switch a display over to the controlling variable during adaptation if
necessary.
To Next Page
Loading...
Need help?
General
