Introduction
1.3 Transportation and storage
Venting Gauge Block Installation Instructions
6 Hardware Installation Manual, 12/2014, A5E34388399-AD
To guarantee sufficient protection during transport and storage, observe the following:
● Keep the original packaging for subsequent transportation.
● Devices/replacement parts should be returned in their original packaging.
● If the original packaging is no longer available, ensure that all shipments are properly
packaged to provide sufficient protection during transport. Siemens cannot assume
liability for any costs associated with transportation damages.
The packaging only provides limited protection against moisture and infiltration.
• Provide additional packaging as necessary.
The sales contract contains the entire obligation of Siemens. The warranty contained in the
contract between the parties is the sole warranty of Siemens. Any statements continued
herein do not create new warranties or modify the existing warranty.
For warranty and non-warranty service, refer to Customer/Product Support in this
publication.
All product designations may be trademarks or product names of Siemens Industry, Inc. or
other supplier companies whose use by third parties for their own purposes could violate the
rights of the owners.
Siemens Industry, Inc. assumes no liability for errors or omissions in this document or for the
application and use of information in this document. The information herein is subject to
change without notice.
Procedures in this document have been reviewed for compliance with applicable approval
agency requirements and are considered sound practice. Neither Siemens Industry, Inc. nor
these agencies are responsible for product uses not included in the approval certification(s)
or for repairs or modifications made by the user.
To Next Page
Loading...
Need help?
General
