Siemens SIPLUS CMS4000 - 4.2.6 Cable Traction Relief; 4.2.7 Sealing of not used round connectors

Operating Instructions SIPLUS CMS4000 IFN AI-D
SIPLUS CMS4000 IFN AI-D
Operating Instructions, 07/2021, A5E32612781A-AB
22
4.2.6 Cable Traction Relief
Caution
You have to prepare adequate cable traction relief!
4.2.7 Sealing of not used round connectors
Seal all not used round connectors with M12 end caps, in order to reach the degree of
protection IP 67. Observe the correct fitting of the end caps! Order Number „Coping Set“
see chapter 7.1.