Siemens SIPLUS CMS4000 - 5.3 Parameterization of IFN AI-D; Diagnosis through X-Tools; Mixed configurations with ION and IFN

Operating Instructions SIPLUS CMS4000 IFN AI-D
SIPLUS CMS4000 IFN AI-D
Operating Instructions, 07/2021, A5E32612781A-AB
25
5.3 Parameterization of IFN AI-D
The IFN AI-D is parameterized through X-Tools. You will find parameterization details in
the „SIPLUS CMS X-Tools Reference Manual”.
5.4 Diagnosis through X-Tools
You will find detailed information in the „SIPLUS CMS X-Tools Reference Manual”
5.5 Mixed configurations with ION and IFN
In case of mixed configurations with IFN (IFN AI, IFN AI-D and IFN VIB-ACC) and ION
(ION Profibus Spy, ION BI, ION AI, ION VIB-A, …) in a single bus line with a
MICROBOX PC, take account of:
Connect the ION and IFN in a single line at plug 2 (Port 3).
The order of the nodes is not relevant.
If an existing MICROBOX PC with CMB IEEE1394A T011 is used, please verify that
plug 2 is connected with Port 3 of the PC/104-card.
A mixed configuration at plug 1 (PC/104-card Port 2 or Port 1) could cause communica-
tion problems and could inhibit the collection of data with the MICROBOX PC.
Picture 13 MICROBOX PC, PCN 427C
plug 2 conneted
with PC/104
-
card
Port3
plug 1 connected
with
PC/104
-
card
Po
rt2