SFP with Optical Interface for 24 km, Single Mode
Description SFP for distances up to 24 km when using singlemode optical fibers
Product code P1Z3210
Connector type Duplex LC
Wavelength λ = 1300 nm
Baud rate 100 Mbit/s
Protocol See information for the module ETH-BD-2FO
Max. line length 24 km for 9 µm/125 µm optical fibers
Distance 24 km
Laser class 1 as per EN 60825-1/-2 With the use of 9 µm/125 µm optical fibers
Transmitter Power Minimum Maximum
Transmitter power coupled in
singlemode optical fibers
-15 dBm -8 dBm
Receiver sensitivity -8 dBm -31dBm
Optical budget 16 dB –
SFP with Electrical Interface
Description SFP with RJ45 connector, for Ethernet protocols via an electrical inter-
face
Product code P1Z3201
Connector type RJ45
Baud rate 100 Mbit/s
Protocol See information for the module ETH-BD-2FO
Max. line length 20 m with Ethernet patch cable CAT 6 S/FTP, F/FTP, or SF/FTP
Interface design Corresponds to IEEE 802.3, 100Base-TX
Removing SFP Pluggable Transceivers
CAUTION
Risk of burns due to high temperatures of the SFP pluggable transceivers
Noncompliance with the safety notes may result in medium or light injuries.
²
The SFP pluggable transceivers can be disconnected and plugged in while in operation. Siemens
recommends switching off the device.
²
Allow the SFP pluggable transceiver to cool as much as possible.
✧ Remove the connecting cables or the dust protection cap that was plugged on in the delivery state from
the SFP pluggable transceiver.
✧ In order to release the interlocking, open the bracket on the SFP pluggable transceiver.
✧ Pull on the bracket in order to pull the SFP pluggable transceiver out of the slot. The removal must be
possible with free movement and without great exertion of force.
✧ Provide the SFP pluggable transceiver with the dust protection cap so that the optics are protected from
contamination.
Technical Data
11.1 General Device Data
908 SIPROTEC 5, Low-Impedance Busbar Protection, Manual
C53000-G5040-C019-C, Edition 04.2021
To Next Page
Loading...
Need help?
General
