Need help?Do you have a question about the Siemens SIPROTEC 5 6MU85 and is the answer not in the manual?
General| Brand | Siemens |
|---|---|
| Model | SIPROTEC 5 6MU85 |
| Category | Industrial Equipment |
| Language | English |
Defines manual purpose, target audience, and scope of application.
Lists related manuals, software, and guides for SIPROTEC 5.
Details product compliance with EU directives and industry standards.
Provides contact info for support and highlights safety warnings.
Covers personnel requirements, proper use, and device symbols.
Specifications for analog inputs, voltage inputs, and transducer inputs.
Settings for time synchronization sources, formats, and time zones.
Parameters and settings for circuit-breaker failure detection.
Settings for detecting and mitigating circuit breaker restrikes.
Parameters for monitoring circuit breaker status.
Settings for definite-time and inverse-time overcurrent protection for phases.
Specifies settings for ground overcurrent protection.
Details settings for directional overcurrent protection for phases.
Covers settings for ground directional overcurrent protection.
Parameters for overvoltage and undervoltage protection stages.
Settings for detecting transformer inrush currents.
Specifies ground fault detection using 2nd harmonic.
Parameters for handling external trip signals.
Settings for automatic reclosing functions.
Parameters for detecting rapid current changes.
Settings for detecting rapid voltage changes.
Outlines parameters for detecting voltage measurement failures.
Specifies response time for VT circuit breaker function.
Covers settings for voltage balance monitoring.
Specifies parameters for voltage sum supervision.
Details settings for voltage phase rotation monitoring.
Outlines parameters for current balance monitoring.
Specifies settings for current sum supervision.
Details settings for current phase rotation monitoring.
Covers settings for temperature monitoring.
Specifies tripping delay for switch-on-fault conditions.
Details settings for detecting broken wires in circuits.
Outlines parameters for monitoring the trip circuit.
Specifies settings for analog channel supervision.
Details tolerances for measured values and statistics.
Covers specifications for analog input units.
Specifies standards for PMU accuracy and data transfer.
Details specifications for current measuring transducers.
Covers setting values and parameters for arc protection.
Specifies operating modes and settings for synchronization.
Outlines settings for closing circuit supervision.
Details settings for monitoring CB wear.
Explains CFC tick consumption calculation and block list.
Specifies supported streams and functionality for process-bus client.
Details supported streams and MU functionality.
Refers to a separate manual for point-on-wave switching data.
To Next Page