Description, device design, dimension drawing
2.5 Buttons and selector switches
SITOP SEL1200-1400
20 Equipment Manual, 06.2020, A5E46496083-2-76
Manually switching an output on and off
An individual output can be switched on and switched off using the button
(ON/OFF/RST)
⑥. When the device is delivered, the outputs are manually switched off.
Switching off an output:
For outputs that are switched on, LED
⑥ of the particular output is lit green. You can switch
off the output by pressing the assigned button (ON/OFF/RST)
⑥. The LED then flashes
orange (output has been manually switched off).
Switching on an output:
For outputs that have been manually switched off, LED
⑥ of the particular output is lit
orange. You can switch on the output by pressing the assigned button (ON/OFF/RST)
⑥.
The LED is then lit green (output is switched on).
Note
An output that has been manually switched
-off can only be manually switched-on again by
manually pressing the button again. It is not possible to switch on an output that has been
manually
switched off using the remote reset signal (RST) ④.
has been manually switched off remains saved (latch) even when the supply
voltage is no longer available, and is a manually switched off when the supply voltage
returns.
To Next Page
Loading...
