To Next PageTo Next Page
Need help?Do you have a question about the Siemens SITOP SEL1200 and is the answer not in the manual?
General| Output Voltage | 24 V DC |
|---|---|
| Output Current | 5 A |
| Efficiency | up to 93% |
| Operating Temperature | -25 °C to +70 °C |
| Power | 120 W |
| Protection Class | IP20 |
| Signaling | LED display |
Using the selectivity module, a 24 V DC output voltage from a regulated power supply can be distributed across eight load circuits.
The input terminals can be used to establish the connection to the supply voltage. The "0 V" connection is used to supply the internal electronics.
The potentiometer on the front of the device is used to set the response threshold of the output current.
The operating state of the outputs is displayed using multi-color LEDs at the front of the device.
An overload is permitted for a defined period of time. The output is electronically shut down after the limit value has been exceeded.
Instructions for connecting the 24 V DC supply voltage to the input terminals of the selectivity module.
Details on connecting loads to the output terminals of the selectivity module.
Specifies the rated voltage, voltage range, overvoltage strength, and input current for the device.
Details output voltage, total tolerance, number of outputs, current capacity, and shutdown characteristics.
Specifies safety standards, protection class, and degree of protection for the devices.
Details electromagnetic compatibility test results for electrostatic discharge, fields, and surge voltages.
