Need help?Do you have a question about the Siemens SITOP PSE200U and is the answer not in the manual?
General| Output Voltage | 24 V DC |
|---|---|
| Number of outputs | 1 |
| Height | 125 mm |
| Depth | 125 mm |
| Mounting | DIN rail |
| Protection | Overload, short circuit |
| Operating Temperature | -25 °C to +70 °C |
Using SITOP modular units or the PSU8600 system within the PCS 7 control system.
Configuring the AS and external peripherals for a redundant 24V power supply.
Developing the AS program by adjusting CFC plans and interconnecting signals.
Monitoring the status of the redundant 24V power supply on the Operator Station.
Configuring the AS and peripherals for the UPS1600 on PROFINET IO.
Creating the AS program for UPS1600 monitoring of signals and status.
Configuring hardware for monitoring UPS1600 signal contacts.
Creating AS program to monitor buffering and battery status via signal contacts.
Monitoring the uninterruptible power supply status on the Operator Station.
Configuring AS and peripherals for selectivity module monitoring and reset.
Creating AS program for selectivity module monitoring and remote reset.
Configuring AS and peripherals for the SITOP PSU8600 power supply system.
Creating AS program for PSU8600, parameterizing symbols and modules.
Configuring AS and peripherals for the redundant PSU8600 system.
Creating AS program for redundant PSU8600, adjusting redundancy module and power supply CFCs.
Operating the SITOP modular system and viewing status information.
Operating the PSU8600 system and viewing status of its components.
To Next Page