SITOP SEL1200-1400
Manual, 06.2019, A5E46496083-1-76
9
Description, device design, dimension drawing
2.1 Device description
Using the selectivity module, a 24 V DC output voltage from a regulated power supply can
be distributed across eight load circuits. The response threshold of the output current can be
individually set for each output using a potentiometer. When the set response threshold is
exceeded, the output is automatically switched off according to a defined switch off
characteristic, and can be switched on again after a wait time using a pushbutton
(ON/OFF/RST) or remote reset (RST). The status of the output is displayed using a multi-
color LED for each output. The status of the outputs can be processed via a group signaling
contact (13, 14) or via a serial single-channel signal.
To Next Page
Loading...
