Siemens SITOP series - Output Characteristics

Technical data
6.2 Output
SITOP modular 1ph/2ph
Operating Instructions, 06.2014, C98130-A7548-A1-3-7629
39
6.2
Output
6EP1333-3BA10
(24 V/5 A)
6EP1334-3BA10
(24 V/10 A)
6EP1336-3BA00
(24 V/20 A)
6EP1337-3BA00
(24 V/40 A)
Output Regulated, isolated DC voltage
Rated voltage value Ua rated
DC
24 V
Total tolerance, static ±
3 %
3 %
3 %
3 %
Static line regulation, approx.
0,1 %
0,1 %
0,1 %
0,1 %
Static load regulation, approx.
0,1 %
0,1 %
0,1 %
0,1 %
Residual ripple in the load
range
Peak-peak, max.
50 mV 50 mV 100 mV 100 mV
Spikes peak-peak, max.
(bandwidth, approx. 20 MHz)
200 mV 200 mV 200 mV 200 mV
Adjustment range
24…28.8 V
Product function / output
voltage can be adjusted
Yes
Output voltage setting
• Remark
Via potentiometer
Max. 120 W
Max. 240 W
Max. 480 W
Max. 960 W
Output derating Ua/T See Figure 6-7 Output derating depending on the ambient temperature at Ia rated
(Page 42)
Output derating Ua/Ia
See Figure 6-8 Output derating depending on the output current at 60° C (Page 42)
Output derating Ua/Ui
• Remark
- - - See Figure 6-9
Output derating
depending on the
input voltage
(Page 43)
The output voltage
must not be set
higher than 24 V for
85 to 93 VAC.
Response when switching
on/off
Overshoot of Ua approx. 3%
Starting delay, max.
1 s
1 s
0.1 s
0.1 s
Voltage rise, typ.
50 ms
50 ms
50 ms
50 ms
Voltage rise time of the output
voltage, maximum
500 ms 500 ms 500 ms 500 ms
Rated current value Ia rated
5 A
10 A
20 A
40 A
Current range
• Remark
0…5 A 0…10 A
+60°..+70° C
derating:
Approx. 2%
Ia rated/K
0…20 A
+60°..+70° C
derating:
Approx. 2%
Ia rated/K
0…40 A
+60°..+70° C
derating:
Approx. 2%
Ia rated/K
Output active power / typical
120 W
240 W
480 W
960 W