Siemens SITOP UPS1600 - 1 Introduction; Purpose of this Document; Technical Support

SITOP UPS1600 under STEP 7 V5
Getting Started,
5
Introduction
1
1.1
Purpose of this document
This Getting Started guides you through configuring the UPS1600 under STEP 7 V5 for the
following two tasks:
● Buffering the S7 IO controller including I/O when the power fails
● Switching off the UPS when the power fails by the user program
Basic knowledge required
The following are required to understand the Getting Started:
● Knowledge about using personal computers with the Windows operating system
● Knowledge about how to configure an uninterruptible power supply using the SITOP
UPS1600, including the S7 IO controller and connected battery modules
● Creating and editing projects under STEP 7 V5.
Range of validity
Getting Started is valid for STEP 7 V5 from version 5.4.
1.2
Technical support
Technical support
Technical support for all IA/DT products can be accessed through the following
communication channels:
● Phone: + 49 (0) 911 895 7222
● E-Mail (mailto:support.automation@siemens.com
)
● Internet:
Online support request form (http://www.siemens.com/automation/support-request
)
Technical documentation on the Internet
Operating instructions and manuals for SITOP are available in the Internet:
Operating instructions/manuals (http://www.siemens.com/sitop/manuals
)
SITOP power supply homepage
General news about our power supplies is available in the Internet at the SITOP home page
(http://www.siemens.com/sitop
).