Note
Only qualied personnel are permitted to install, commission or service this device.
Wear the prescribed protective clothing. Observe the general equipment regulations and safety
regulations for working with high-voltage installations (e.g. DIN VDE, NFPA 70E as well as
national or international regulations).
The limits given in the technical data must not be exceeded even during startup or testing of the
device.
Before connecting the device, make sure that the line voltage matches the specications on the
rating plate.
Before you start up the device, check that all connections are correct.
Before power is applied to the device for the rst time, it must have been located in the operating
area for at least two hours in order to reach temperature balance and avoid humidity and
condensation.
Condensation on the device is not permissible during operation.
Safety notes
2.3 Ambient temperature
Installation and maintenance instructions for Power Factor Correction (PFC) capacitors
10 Installation Manual, 05/2022, L1V30884033A
To Next Page
Loading...
