iii
SM 338 Equipment Manual
(4) J31069-D401-U1-A0-7618
Notes on the CE Seal
The following applies to the product described in this manual.
Products bearing the CE seal meet the requirements of EU Directive
89/336/EEC ’Electromagnetic Compatibility’ and the harmonized
European standards (EN) listed therein.
In accordance with article 10 of the a bove--mentioned EU Directive, the EU
declarations of conformity are held available for inspection by responsible
authorities at the addresses listed below:
Siemens Aktiengesellschaft
Bereich Automatisierungstechnik
AUT7 WKF KB2
Postfach 2355
D-90713 Fürth
The products have been designed for use in the industrial area and meet the
following requirements:
Area of Application
Requirements
Emitted interference Immunity
Industry EN 50081-2 : 1993 EN 50082-2 : 1995
The products meet the requirements if you:
1. Observe the installation guidelines and safety notes containe d in the ap-
plicable manuals and supplementary documentation, both for the pro-
grammable system and the individual module.
2. Observe the rules below.
The programmable systems and the listed modules must be installe d in
grounded, closed metal enclosures (e.g., switching cabinets).
All signal lines outside this enclosure must be shielde d as described in the
equipment manuals. The shields of the signal lines must be applied to the
shield bar at the entrance to the cabinet.
EU EMC directive
89/336/EEC
Area of application
Observing the
installation guide-
lines
Installing the
devices
To Next Page
Loading...
