deRinse aid system
Additional runtime in
minutes
6
2.Fill in the rinse aid up to the max
mark.
Additional water consumption
in liters
5
Additional consumption of electricity
in kWh
0.05
The stated consumption values are
laboratory measurements according
to the currently valid standard and
determined using the Eco 50°
program and the factory-set water
hardness value of 13 - 16 °dH.
Max
3.If rinse aid has overflowed, remove
it from the rinse container.
K1Lard rinsing system 1 rinse aid system
Overflowing rinse aid can lead to
excessive foam formation during
the rinse cycle.
Rinse aid system
11.1 Rinse aid
4.Close the lid of the rinse aid
reservoir.
For optimal drying results, use rinse
aid.
Only use rinse aid designed for
household dishwashers.
aThe lid clicks into place audibly.
11.2 Adjust the amount of rinse
aid added
Fill in rinse aid
If the rinse aid refill indicator lights
up, add rinse aid. Only use rinse aid
designed for household
dishwashers.
1.The tab on the lid of the rinse aid
reservoir
press and lift.
If streaks or water stains remain on
the dishes, change the amount of rinse
aid added.
1. press.
2.To open the basic settings,
3 seconds
press.
aThe display shows H:xx. a
The display shows .
2
3. Press repeatedly until
the display shows the factory-set
value r:05.
4. or press repeatedly until the
appropriate amount of rinse aid has
been added.
– A low setting adds less rinse aid
to the wash cycle and reduces
streaks on the dishes.
1
30
To Next Page
Loading...
Need help?
General
