Basic settingsde
basic
position
Display text
rc:01
Selection Description
Remote start rc:00 - rc:02
→
"Remote Start", page
45
activate or deactivate.
The following settings are
possible:
¡With the setting "rc:00"
the function is permanently
deactivated.
¡With the setting "rc:01"
The function can be
selected using the button.
→
"Activate Remote Start",
page 45
¡With the setting "rc:02"
the function is permanently
activated.
This basic setting is only
available after you have
connected the device to the
Connected to the Home
Connect app.
→
"Home Connect",
page 44
Factory setting re: Start with
Y:ES
Confirm with
Reset changed settings to
factory defaults. The settings
must be made for initial
commissioning.
1Factory setting (may vary depending on device type)
15.2 Change basic settings
aThe display shows H:xx. a
The display shows .
4. Press repeatedly until the
display shows the desired setting.
Tip:Connect your device to a mobile
device. You can easily adjust all
settings using the Home Connect
app.
5. or press repeatedly until the
display shows the appropriate value.
You can change several settings.
1.Open the device door.
2. press.
6.To save the settings,
Press for 3 seconds.
3.To open the basic settings,
3 seconds
press.
7.Close the appliance door.
43
To Next Page
Loading...
Need help?
General
