3.Make sure that the drain hose is not
kinked, crushed or twisted.
Setting up and connecting
4.2 Set up and connect the
device
You can install your under-counter
device or integrated device in the
kitchen unit between wooden walls
and plastic walls. If you subsequently
set up your device as a free-standing
device, you must secure your device
against tipping over, e.g. B. by
screwing on the wall or by installing it
under a continuous worktop that is
firmly connected to the neighboring
cabinets.
1.
Follow the safety instructions.
→
page 4
4.Make sure that there is no cover in
the drain that prevents the waste
water from flowing out.
4.4
Drinking water connection
Connect
your device to a drinking
water connection.
Install
drinking water connection
Hints
¡Make sure
you do that
Connect the device to a water inlet
with a safety device to prevent
drinking water contamination
through backflow (according to DIN
EN 1717). The connection valves/
water taps provided for this purpose
are equipped with this safety device
if the house is installed correctly.
¡If you replace the device,
you must use a new water inlet
hose.
2.
Follow the instructions for electrical
connection.
3.Check
the scope of delivery and
the condition of the device.
4.Take
the required installation dimensions
from the assembly instructions.
5.
Set up the device horizontally using
the adjustable feet.
Make
sure you have a secure footing.
6.
Install the waste water connection.
→
page 12
1.Please refer to the assembly
instructions provided for the
necessary steps.
7.
Install the drinking water
connection. →
page 12
8th.Connect the device to power.
2.
Connect the device to the drinking
water connection using the
included parts.
4.3
Waste water connection
Connect your device to a wastewater
connection so
that water
contaminated by the rinse cycle can
drain away.
Observe
the technical data.
3.
Make sure that the drinking water
connection is not kinked, crushed or
twisted.
Install waste
water connection
1.
Please refer to the assembly
instructions provided for the
necessary steps.
4.5
Electrical connection
Connect the device electrically
2.Connect the waste water hose to
the drain connection of the siphon
using the included parts.
Hints
¡Observe
the safety instructions
wise
→
page 4
.
12
To Next Page
Loading...
Need help?
General
